Installing the module

  1. Power off the system and while taking electrostatic discharge precautions, remove the module from its packaging.

  2. Open the computer case and locate an empty PCIe slot. If necessary, follow the instructions that your computer manufacturer supplied.

    You must only install your module into a PCIe slot. See the instructions that your computer manufacturer supplied to correctly identify the slots on your computer.

    Minimum requirement:

  3. If there is a blanking plate across the opening to the outside of the computer, remove it. Check that the opening is large enough to enable you to access the module back panel.

  4. Insert the contact edge of the module into the empty slot. Press the card firmly into the connector to ensure that:

    • The contacts are fully inserted in the connector

    • The back panel is correctly aligned with the access slot in the chassis

  5. Use the bracket screw or fixing clip to secure the module to the computer chassis.

  6. Replace the computer case.

After installing the module

If the Security World software has not already been installed, you must install the Security World Software by following the instructions at Installing the software.

Although methods of installation vary from platform to platform, the Security World Software should automatically detect the module on your computer and install the drivers. You do not have to restart the system.