Before installing the module
Module pre-installation steps
Check the module to ensure that there is no sign of damage or tampering:
-
Check the epoxy resin security coating or metal lid of the module for obvious signs of damage.
Fitting a module bracket
Do not touch the connector pins, or the exposed area of the module without taking ESD precautions.
To fit the full height bracket to the module:
-
Remove the two screws from the solder side of the module.
-
Remove the low profile bracket.
-
Fit the full height bracket to the component side of the module.
-
Insert the two screws into the solder side of the module to secure the bracket. Do not over tighten the screws.